AL-1611/AL-1622
UNPACKING AND INSTALLATION
5 – 3
13) Store the pressure plate lock which has been removed in step 5 and
the screw which has been removed in step 2 in the front of the
paper tray.
• To store the pressure plate lock, rotate the lock to fix it on the relevant
location.
• For AL-1622, follow steps 3), 4), 13) for both the upper and lower
trays except for storage of the screw.
14) Push the pressure plate down until it locks in place.
15) Squeeze the lock lever of the front guide and slide the front guide to
match the width of the paper.
16) Move the left guide to the appropriate slot as marked on the tray.
• When using A3 copy paper, store the left guide in the slot at the left
front of the paper tray.
17) Load copy paper into the tray.
• Set the paper along the guides.
• The tray holds up to 250 sheets of about 9kg bond paper.Do not load
paper above the maximum height line.
18) Push the paper tray firmly back into the copier.
19) Ensure that the power switch of the copier is in the OFF position.
Insert the supplied power cord into the power cord socket at the
rear of the copier.
• If you use the copier in a country other than the country where the
copier was purchased, you will need to make sure that your local
power supply is compatible with your model. If you plug the copier
into an incompatible power supply, irreparable damage to the copier
will result.
20) Plug the other end of the power cord into the nearest outlet.
• Only insert the power cord into a properly grounded wall socket.
Do not use extension cords or power strips.
4. CHANGING THE COPY PAPER SIZE IN
THE TRAY
1) Gently lift and pull out the paper tray until it stops.
2) Push the pressure plate down until it locks in place.
3) Squeeze the lock lever of the front guide and slide the front guide to
match the width of the paper.
Pressure
plate lock
Screw
Front guide
Left guide
Maximum height line
Left guide
Front guide
