EN-6
Using the 3D Glasses
Removing the Battery for Recycling
The following instruction and procedure is provided
solely as a guide for the safe removal of the Li-ion battery
for proper disposal.
This product is not repairable.
Do not attempt to replace the battery; once
the 3D glasses are taken apart, they cannot be
reassembled or used again.
- Please take special care in handling small parts such as
screws specially around children that can accidentally
swallow them.
- Be very careful in handling the battery to prevent it from
leaking.
- Do not attempt to dismantle or puncture the battery.
- Do not use this battery for any other purpose. Recycle
properly after removing it from the 3D Glasses.
If you have any question regarding proper recycling
please call 1-800-822-8837 (see page 8 for more details).
1
Pull out the nose pad with your fingers.
2
Remove the five screws with a Phillips screwdriver
(commercially available).
3
Pull the front casing outward with your fingers
while pulling the base of the right temple arm
inward with your fingers (
s
).
1
Front casing
2
Base
3
Right temple arm
4
Cut off the three cables of the rechargeable
battery unit one by one with a pair of scissors.
• There is the rechargeable battery unit inside
2
on
the right temple arm shown below.
• Insulate the tip of the removed rechargeable
battery cables, with material such as electrical
tape, be sure to insulate all three battery cable
tips to prevent the conductor wires from touching
each other.
1
Right temple arm
2
Rechargeable battery unit
3
Rear casing
5
Pull out the entire rechargeable battery unit and
remove it from the rear casing.
NOTE
• Used batteries should be handled in accordance with
local laws and regulations.
AN-3DG20̲EL̲E.indd 6
AN-3DG20̲EL̲E.indd 6
2011/06/03 13:17:18
2011/06/03 13:17:18
