12
F-type connector should be
fi
nger-
tightened
only.
When connecting the RF cable to the TV set, do not
tighten F-type connector with tools.
If tools are used, it may cause damage to your TV
set. (The breaking of internal circuit, etc.)
1. A 75-ohm system is generally a round cable with F-type
connector that can easily be attached to a terminal
without tools (Commercially available).
2. A 300-ohm system is a
fl
at “twin-lead” cable that can be
attached to a 75-ohm terminal through a 300/75-ohm
adapter (Commercially available).
Using the remote control unit
Use the remote control unit by pointing it towards the remote control sensor on
the TV. Objects between the remote control unit and the remote control sensor
may prevent proper operation.
Cautions regarding remote control unit
• Do not expose the remote control unit to shock.
In addition, do not expose the remote control unit to liquids, and do not place in an area
with high humidity.
• Do not install or place the remote control unit under direct sunlight. The heat may cause
deformation of the remote control unit.
• The remote control unit may not work properly if the remote control sensor on the TV is
under direct sunlight or strong lighting. In such cases, change the angle of the lighting
or the TV, or operate the remote control unit closer to the remote control sensor.
Antennas
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of
connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an
F-type connector, plug it into the antenna terminal at the rear of the TV set.
Preparation
300-ohm twin-lead (flat)
300-ohm twin-lead
75-ohm coaxial cable (round)
75-ohm coaxial cable
Cable TV lead-In
or
IN OUT
300-ohm
twin-lead
VHF
ANTENNA
UHF
ANTENNA
Combiner
(commercially
available)
or
300/75-ohm adapter
(commercially available)
Coaxial cable
(commercially available)
Home Antenna
terminal (75-ohm)
75-ohm coaxial cable (round)
Coaxial cable
(commercially available)
Home Antenna
terminal (75-ohm)
300-ohm twin-lead cable (
fl
at)
F-type connector
75-ohm coaxial cable (round)
Connecting Antenna Cable
1
Cable without a
CATV
converter
3
Combination VHF/
UHF
antenna
4
Separate VHF/
UHF
antenna
2
VHF/UHF antenna
• Connect the antenna cable to the
TV using one of the methods in the
illustration as shown (
1
,
2
,
3
or
4
).
To TV antenna
terminal
F-type connector
75-ohm coaxial cable
NOTICE
5X20431A_E_.indb 12
5X20431A_E_.indb 12
5/19/2006 6:35:34 PM
5/19/2006 6:35:34 PM