Sharp Aquos LC-24LE150M, Operation Manual

3

4

Attaching the stand

• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from 

being damaged.

1

Confi rm the screws supplied with the TV.

Screw driver

Screw

Soft cushion

Screws (

m 

4)

(used in step 1 and 3)

2

Insert and hook post into stand base slot holes. 
(

1

) 

Fix the post using short screw.

3

Insert the stand base to the stand post on the 
bottom of the TV. (

2

)

4

Insert and tighten the 3 screws into the 3 holes 
on the bottom of the stand base. (

3

)

NOTE 

• To detach the stand, perform the steps in reverse order.
• Do not attach or detach the stand without holding it. Doing 

so can cause the stand to fall, resulting in serious personal 
injuries as well as damage to the stand.

Antenna connection

Connect antenna cable to the antenna terminal

or

If your outdoor antenna uses a 75-ohm coaxial 
cable with a standard DIN45325 plug (IEC 
169-2), plug it into the antenna jack at the rear of 
the set.

If your outdoor antenna uses a 300-ohm twin-
lead fl at feeder, connect a 300-ohm to 75-ohm 
impedance converter and plug it into the antenna 
jack at the rear of the set.

CAUTION 

• 

TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH 
THE AC CORD CONNECTED.

NOTE 

• Place the TV close to the AC outlet, and keep the power plug within reach.

LC-24LE150M_F906_EN.indd   2

LC-24LE150M_F906_EN.indd   2

6/11/2013   12:00:27 PM

6/11/2013   12:00:27 PM