Menu operations
Surround
Menu Operation: A (page 12)
Surround function allows you to enjoy realistic “live”
sound.
NOTE
• You can also choose surround effects by pressing
SURROUND
on the remote control unit.
Auto Vol.
Menu Operation: A (page 12)
Different sound sources, fairly often do not have the
same volume level, for example the changing from
movie to the advertisements. The Automatic Volume
Control (Auto Vol.) solves this problem and equalises
the volume levels.
Clear Voice
Menu Operation: A (page 12)
This function emphasises speech voice against the
background noise for more intelligibility. It is not
recommended for music sources.
Power Control menu
MENU
[Power Control]
Power Control
No Signal Off
No Operation Off
[Disable]
[Disable]
Setup
No Signal Off
Menu Operation: A (page 12)
When set to “Enable” the TV will automatically enter the
standby mode if there is no signal input for 15 minutes.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
• This function is not available in DTV mode.
No Operation Off
Menu Operation: A (page 12)
When set to “Enable” the TV will automatically enter
the standby mode if no operations are performed for 3
hours.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
Power Management
Menu Operation: A (page 12)
When set, the TV will automatically enter the standby
mode.
Off:
• No power management
• Factory preset value.
Mode1:
• If there is no signal input for 8 minutes, the
TV enters the standby mode.
• Even if you start using the PC and the
signal inputs again, the TV stays in standby
mode.
• The TV turns on again by pressing
a
on
the TV or
B
on the remote control unit.
(See page 8.)
Mode2:
• If there is no signal input for 8 seconds, the
TV enters the standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing
a
on
the TV or
B
on the remote control unit.
(See page 8.)
Setup menu
MENU
[Setup]
Setup
Option
Child Lock
Auto Installation
Programme Setup
Position
WSS
4:3 Mode
[Panorama]
[On]
[Off (0V)]
Supply Voltage
[English]
Language
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
Press
MENU
and the MENU screen displays.
Press
c
/
d
to select “Setup”.
Press
a
/
b
to select “Auto Installation”, and
then press
OK
.
If you have already set the PIN under “Child
Lock”, enter it here.
• See page 17 for setting PIN.
Press
c
/
d
to select “Yes”, and then press
OK
.
You can set language and country the same as
in the initial auto installation. Follow steps 1 and
2 on page 8.
1
2
3
4
5
15
Item
TV/DTV/AV only
TV/AV only
TV/DTV/AV only
PC only
TV only
LC-26D44E-gb.indd 15
LC-26D44E-gb.indd 15
2008/02/19 10:21:30
2008/02/19 10:21:30
