14
Setup menu
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Auto Installation”, and then
press
OK
.
If you have already set the PIN under “Child Lock”,
enter it here.
• See page 16 for setting PIN.
4
Press
c
/
d
to select “Yes”, and then press
OK
.
5
You can set language and country the same as in
the initial auto installation. Follow steps 1 and 2
on page 7.
Programme Setup
This section describes how to set up analogue TV
channels manually.
Menu operations
MENU
[Setup]
Setup
Option
Child Lock
Auto Installation
Programme Setup
Position
WSS
4:3 Mode
[Panorama]
[On]
[English]
[Normal]
Language
Rotate
Auto Search
You can automatically search for and download TV
channels by performing the procedure below. This is
the same function as from programme auto search to
preset download in Auto Installation.
1
Repeat steps 1 to 4 in
Programme Setup
.
2
Press
c
/
d
to select “Yes”, and then press
OK
.
1
Programme auto search
2
Auto labelling
3
Auto sorting
4
Preset download
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Programme Setup”, and
then press
OK
.
If you have already set the PIN under “Child Lock”,
enter it here.
• See page 16 for setting PIN.
4
Press
a
/
b
to select “Auto Search”, “Manual
Adjust”, “Sort” or “Erase Programme”, and then
press
OK
.
Auto Search
Manual Adjust
Sort
Erase Programme
No
Yes
Power Control menu
No Signal Off
Menu Operation: A (page 11)
When set to “Enable” the TV will automatically enter
the standby mode if there is no signal input for 15
minutes.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
MENU
[Power Control]
Audio
Power Control
No Signal Off
No Operation Off
[Disable]
[Disable]
No Operation Off
Menu Operation: A (page 11)
When set to “Enable” the TV will automatically enter
the standby mode if no operations are performed for
3 hours.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
Power Management
Menu Operation: A (page 11)
When set, the TV will automatically enter the standby
mode.
Off:
• No power management
• Factory preset value.
Mode1:
• If there is no signal input for 8 minutes, the TV
enters the standby mode.
• Even if you start using the PC and the signal
inputs again, the TV stays in standby mode.
• The TV turns on again by pressing
a
on the TV
or
B
on the remote control unit. (See page 7.)
Mode2:
• If there is no signal input for 8 seconds, the
TV enters the standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing
a
on the TV
or
B
on the remote control unit. (See page 7.)
TV/AV only
TV/AV only
TV only
TV only
PC only
Item
LC-32GA8E_GB_b
06.4.28, 10:19 AM
14
