17
Watching TV
Simple button operations for
changing channels
You can change channels in several ways.
Using CH
a
a
a
a
a
/
b
b
b
b
b
on the remote control unit
• Press
CH
a
a
a
a
a
to increase channel number.
• Press
CH
b
b
b
b
b
to decrease channel number.
NOTE
•
CH
s
/
r
on the Display operates the same as
CH
b
b
b
b
b
/
a
a
a
a
a
on
the remote control unit.
Channel display
MONO
12
SAT.1
12
SAT.1
B/G
PAL
(Example)
CH
s
/
r
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons
0
to
9
.
a
To select a 1-digit channel (e.g. channel 2):
• Press
2
.
If
“2”
is indicated and the picture does not
change, press
o
to switch over to the 1-digit select
mode and press
2
again.
To select a 2-digit channel (e.g. channel 12):
• Press
o
to set the 2-digit select mode. Press
1
,
followed by
2
.
NOTE
• Complete this procedure within 3 seconds, otherwise the
selection will not be made on the 2-digit channel mode.
Using Flashback (
A
) on the remote
control unit
Press
A
to switch the currently tuned channel to the
previously tuned channel.
Press
A
again to switch back to the currently tuned
channel.
When viewing Teletext information
View a page directly which is 3-digit page number from
100 to 899 by pressing buttons
0
to
9
. With Teletext,
you do not use
o
. (See page 64).
Channel display changes approximately after 3
seconds as shown below.
