33
Watching TV
Auto power-off after the end of broadcast
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “ECO”.
• ECO menu displays.
3
Press
a
/
b
to select “No signal off”, and then
press
ENTER
.
4
Press
c
/
d
to select “Enable”, and then press
ENTER
.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• “Disable” is the factory preset value.
• When a TV programme finishes, this function may not operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “ECO”.
• ECO menu displays.
3
Press
a
/
b
to select “No operation off”, and
then press
ENTER
.
4
Press
a
/
b
to select “30min.” or “3hr.”, and
then press
ENTER
.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• “Disable” is the factory preset value.
Quick start
You can reduce the TV’s start-up time after turning on
the power with the remote control unit.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Quick start”, and then
press
ENTER
.
4
Press
c
/
d
to select “On” or “Off”, and then
press
ENTER
.
Selected item
Description
On
The TV quickly starts up from standby,
19 W or more of power consumption is
required during standby.
Off
Power consumption is less than 1 W.
Picture size settings
Selecting the Wide Screen Signalling
(WSS) picture size automatically
WSS allows a television to switch automatically among
the different screen formats.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “WSS”, and then press
ENTER
.
4
Press
c
/
d
to select “On” or “Off”, and then
press
ENTER
.
NOTE
• Try to set WIDE mode if an image does not switch to the
correct screen format. When the broadcast signal contains
no WSS information, the function will not work even if
enabled.
Selecting the Wide Screen Signalling
(WSS) picture size manually
The WSS signal has 4:3 auto-switching that allows you
to select between Panorama and Normal.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “4:3 mode”, and then
press
ENTER
.
4
Press
c
/
d
to select “Panorama” or “Normal”,
and then press
ENTER
.
WSS signal 4:3 screen
4:3 mode “Panorama”
4:3 mode “Normal”
Selected item
Description
Panorama
Wide image without side bars
Normal
Normal range keeping 4:3 or 16:9 aspect
ratio
LC-40LB700X_en_d.indd 33
LC-40LB700X_en_d.indd 33
8/7/2009 12:36:39 PM
8/7/2009 12:36:39 PM
