90
Appendix
Reset
If complex adjustments are made and the settings
cannot be restored to normal, you can reset the
settings to the factory preset values.
1
Press
MENU
and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Reset”, and then press
ENTER
.
4
If you have already set the password, enter it
here.
• “Return to factory pre-settings” displays on the
screen.
5
Press
c
/
d
to select “Yes”, and then press
ENTER
.
• “Now, TV will restart automatically. OK?” displays
on the screen.
6
Press
c
/
d
to select “Yes”, and then press
ENTER
.
• “Now initialising...” displays on the screen and
blinks.
• After the reset has completed, the power shuts
off and then comes back on. The screen will have
returned to its original settings.
Now initialising...
After factory presetting,
TV will restart automatically
7
Press
a
/
b
to select the desired language
listed on the screen, and then press
ENTER
.
Press
c
/
d
to select “HOME” or “STORE”,
and then press
ENTER
.
8
Press
ENTER
.
Digital Search
Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto Installation” in “Setup” section
(refer chapter “Watching TV” on manual).
• Major analogue channel settings are pre-set.
However if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto installation” in “Setup” section.
(See page 22.)
9
The TV searches for, sort and stores all the
receivable TV stations according to their settings and
the connected antenna.
• To abort the initial auto installation in progress,
press
RETURN
.
NOTE
• When the TV is in STORE mode, repeat steps 1 to 7 to
change to HOME mode.
Download setup
The TV automatically determines whether a new software
version is available when the TV is in standby mode.
Selected item
Description
Yes
Automatically searches for new software
updates available when the TV is in
standby mode.
No
Does not search for update information.
Now
Checks if there is new software
immediately.
Downloading the software
You can select the method of update.
1
If the software is updated, the confi rmation
message “New download information has been
detected.” appears
• If the TV receives the update service while in standby
mode, a confi rmation message displays after turning
on the power.
2
Follow the screen prompts.
Selected item
Description
Yes
Starts downloading immediately. It takes
approximately one hour to update. You
cannot carry out other operations while
downloading.
• Cancels the download by pressing
ENTER
on the remote control unit
when “Discontinue” is displayed on the
screen during the update.
No
Starts downloading automatically several
minutes after entering standby mode.
NOTE
• The TV must remain in standby mode for download. Do not
turn off the power using
POWER
on the TV.
• Updating the software may take some time.
Information
Message list
When a new broadcast station is detected, the message
is updated in the “Message list” of the “Information” menu.
Receiver report
Display reports regarding failures and changes for
timer settings.
Identifi cation
You can check the current version of the software on
the screen.
LC-40LB700X_en_j.indd 90
LC-40LB700X_en_j.indd 90
8/7/2009 12:39:15 PM
8/7/2009 12:39:15 PM
