Quick guide
Initial auto installation
When the TV powers on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Checking signal strength and
channel strength
If you install a DVB-T antenna for the first time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking the
antenna setup screen.
Press
MENU
and the menu screen displays.
Press
c
/
d
to select “Setup”.
Press
a
/
b
to select “Aerial Setup-DIGITAL”,
and then press
OK
.
E
Checking signal strength
Press
a
/
b
to select “Signal Strength”.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max
0
CH No.
21
0
Current Max
0 0
E
Checking channel strength
Press
a
/
b
to select “Channel strength”, and
then press
OK
.
• You can input a specified frequency band using
0
-
9
numeric buttons.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max
0
CH No.
21
0
Current Max
0 0
2 6 5
.
2
MHz
Position and align the antenna so that the
maximum possible values for “Signal Strength”
and “Quality” are obtained.
NOTE
• The values of “Signal Strength” and “Quality” indicate when
to check the appropriate alignment of the antenna.
1
2
3
4
Press
a
on the TV.
• The initial auto installation wizard appears.
Setting the on-screen display language
English
Italiano
Svenska
Setting the country (Location of TV set screen)
Austria A B/G
Finland FIN B/G
Greece GR
B/G
• The Location of TV set screen only appears during
the first installation.
Starting channel search
Analogue Search
Digital Search
• If you want to search for more broadcasts, execute
“Auto Installation” again from the Setup menu.
1
2
3
4
Confirm the following before turning on
the power
E
Is the antenna cable connected?
E
Is the AC cord plugged in?
Press
a
/
b
/
c
/
d
to select the desired language,
and then press
OK
.
Press
a
/
b
/
c
/
d
to select your country or area,
and then press
OK
.
Press
c
/
d
to select “Digital Search” or “Analogue
Search”, and then press
OK
.
The TV searches for, sorts and stores all the
receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress, press
END
.
NOTE
• If you turn off the power on the TV after performing step 4,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the Setup menu. (Page 26)
• The initial auto installation wizard will go off if you leave
the TV unattended for 30 minutes before searching for
channels in step 5.
5
9
LC-42X20E-gb.indd 9
LC-42X20E-gb.indd 9
2007/09/04 16:31:19
2007/09/04 16:31:19
