EN
- 2
Follow the steps below one by one when using the TV for the
fi
rst time. Some steps may not be necessary
depending on your TV installation and connection.
Connecting Antenna Cable
Connect an antenna cable to the antenna terminal.
Cable TV lead-In
Home antenna terminal
(75-ohm)
Home antenna terminal
(75-ohm)
Coaxial cable
(commercially available)
Coaxial cable
(commercially available)
To TV
antenna
terminal
To TV
antenna
terminal
75-ohm coaxial cable (round)
1
Cable without a CATV converter
2
VHF/UHF antenna
•
Connect the antenna
cable to the TV using one
of the methods in the
illustration as shown (
1
or
2
)
CABLE
Plug the AC cord into the AC outlet.
NOTICE
F-type connector should be fi nger-
tightened only.
When connecting the RF cable to the TV set, do not tighten
F-type connector with tools.
If tools are used, it may cause damage to your TV set.
(The breaking of internal circuit, etc.)
F-type connector
75-ohm coaxial cable
•
Place the TV close to the AC outlet, and keep the power plug within reach.
CAUTION
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH
UN-INSULATED PARTS OF ANY CABLES WITH THE AC CORD
CONNECTED.
The drawings used throughout this model are based on the
PN-UH701 model.
Press
POWER
on the TV.
Run the initial installation.
•
Follow the guide on the TV screen
to set the following settings.
Language setting
TV Location setting
Channel search setting
Smart TV setting
SHARP Legal setting
Completed
Initial installation
Summary of Contents for AQUOS PN-UH601
Page 4: ...LIMITED WARRANTY 4 ...
Page 44: ......