- 38 -
•
Do not touch ROBOQUL (sold separately) and the specified charger (sold
separately) with wet hands. Doing so may cause electric shock.
•
Do not splash water onto ROBOQUL (sold separately), the specified charger
(sold separately) or optional accessories when using the equipment and do
not use it in places where water is regularly used such as a bathroom,
shower room, kitchen and lavatory. Doing so may cause fire, burnout,
electric shock, a fault, etc. Also, do not take it in a bathroom etc. even when
not charging. Doing so may cause fire, burnout, electric shock, a fault, etc.
Washing the Product
If any stain, dust, sand, soft drink, etc. is attached to the surface of the
product, gently wipe it off with a cloth and wash the product under a mild
water flow (up to 6 liters/min) of tap water at room temperature (5°C to 35°C)
approximately 10 cm away from the faucet or shower head.
Hold the au IC Card/microSD memory card tray so that it does not open, and
wash the product with your hands without using a brush or sponge.
After washing the product, drain water off and then use the product.
•
Make sure that the au IC Card/microSD memory card tray is securely closed
before washing the product.
•
Do not wash the product with a washing machine or an ultrasound bath.
•
The earphone/microphone jack section and external connection jack section
are especially subject to stain such as dust or sand adhesion. Wash away
stain carefully so as not to keep it remaining in the sections. Also, after
washing it away, make sure the sections get sufficiently dried off before
using the product. Using the product with sand or water drops remaining in
the jack sections may cause fault.
•
When cleaning the earphone/microphone jack section and external
connection jack section, do not use tools such as a cotton swab or jam a
cloth into the jack sections. Doing so may cause impairment of waterproof/
dustproof property etc., resulting in fire, burns, or a fault.
•
Never put the product in a microwave oven for drying it. Doing so may cause
the internal battery to leak liquid, overheat, rupture or ignite. Also, doing so
may cause the product to overheat, emit smoke, ignite or cause destruction
of circuit components.
•
Do not expose the product to hot air from a hair dryer or leave it in a high
temperature environment for drying it. Doing so may cause the product to
deform, discolor, get out of order, etc.
