DG
B
1 – 31
STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following symbols appear in the
display, solve the problem immediately referring to both the table below and the relevant page.
Steadily
lit
Blinking
Steadily
lit
Blinking
Blinking
Blinking
w
s
t
Q
n
Be sure to use only genuine SHARP
parts and supplies.
Use the following procedure to display the total number
of copies.
DISPLAYING TOTAL NUMBER OF COPIES
1. Press the clear (
>
) key to reset the
display to zero.
2. Press and hold down the clear (
>
)
key for approximately 5 seconds. The
total number of copies will appear in
two steps, each with three digits.
Example:
Total number of copies is 1,234.
The memory backup funtion for facsimile maintains data only for one hour. When any facsimile data
is kept in memory,do not keep the copier powerturned off (by unplugging the power cable) for a long
time even if the copier stops due to trouble. (AR-F151)
Steadily
lit
Indication
Drum replacement
required indicator
TD cartridge replace-
ment required indicator
Misfeed indicator
SPF / R-SPF misfeed
indicator
Maintenance indicator
The paper tray indicator
is blinking.
„CH“ is blinking in
the display.
„CH“ is steadily lit in the
display.
„P“ is blinking in
the display.
A letter and a number
appear alternately.
Cause and remedy
Replacement of drum cartridge will be needed soon. Obtain a
new cartridge. p. 1-22
Drum cartridge must be replaced. Replace it with a new one.
p. 1-22
Replacement of TD cartridge will be needed soon. Obtain a new
cartridge. p. 1-20
TD cartridge must be replaced. Replace it with a new one.
p. 1-20
A misfeed has occurred. Remove the misfed paper referring to
the description of „Misfeed removal.“ p. 1-25. Lever of fusing area
is not raised. p. 1-26 The lower side cover may be open. If so, close it.
An original misfeed has occurred in the SPF or in the R-SPF.
Remove the misfed originals referring to the description of
"Misfeed in the SPF or in the R-SPF". p. 1-28.
Service by an authorized SHARP service technician is required.
p.1-24
The paper tray is not installed properly. Push the tray into the
copier securely. p.1-7.
The TD cartridge is not installed. Check if the cartridge is
installed.
Side cover is open. Close the side cover securely by pressing
the round projections near the side cover open button. p. 1-21
Paper tray or bypass tray is empty. Load copy paper. p. 1-7
A misfeed has occurred in the paper tray or bypass tray. Remo-
ve the misfed paper. p. 1-26
Paper tray is not securely installed. Push the tray in securely.
p. 1-7
The copier will not function. Turn the power switch off and then
switch it on,and if there is again an error, remove the power cord
from the outlet, and contact your authorized Service representative.
AR-150 series_EU1.p65
20/09/99, 12:02
31
