45
6
This chapter describes how to replace the toner cartridge and how to clean unit.
TONER CARTRIDGE REPLACEMENT
When the toner cartridge replacement required (
) indicator lights up, replacement
of the toner cartridge will be needed soon. Obtain a new cartridge. When the toner
cartridge replacement required (
) indicator blinks, the toner cartridge must be
replaced before copying can be resumed. Replace the toner cartridge by following
the procedure below.
1
Open the multi-bypass tray, side cover, and front cover, in that
order.
To open the multi-bypass tray, see
"The multi-bypass tray" (p.10).
2
Push gently on both sides of
the front cover to open the
cover.
Be sure to use only genuine SHARP parts and supplies.
For best copying results, be sure to use only SHARP Genuine
Supplies which are designed, engineered, and tested to maximise the
life and performance of SHARP copiers. Look for the Genuine
Supplies label on the toner package.
During long copy run of a dark original, the start (
) indicator may
blink, the indicator light up, and the unit stop, even though toner is left.
The unit will feed toner up to 2 minutes and then the start (
) indicator
will light up. Press the start (
) key to restart copying.
6
MAINTENANCE
