26
MAKING COPIES
1
Press the INTERRUPT key.
●
The copier will return to the initial settings.
●
If this copier has been programmed in the auditing mode using user
program No. 10, “
– – –
” will appear in the copy quantity display.
Enter your account number using the numeric keys. The number of
copies of the interrupt copying will be accumulated against this
account number. See page 13.
●
When an optional SPF or RSPF is being used, the copier will stop after
completing the copying of the original which has been fed into the SPF
or RSPF.
2
When the copier stops to place an original for interrupt
copying on the original table or remove any remaining
originals on the SPF or RSPF and replace with originals
for interrupt copying via the SPF or RSPF.
3
Select the desired available copier functions.
4
Set the number of copies.
5
Press the START key.
●
The interrupt copies will be offset from the previous copies when user
program No. 19 is enabled. See page 36.
6
When all INTERRUPT copies are finished, press the
INTERRUPT key again to cancel the INTERRUPT mode,
and remove the original used for interrupt copying.
●
The previous copy quantity, copy ratio, copy density, and paper size
will be automatically restored.
7
Replace the original(s) for the interrupted job and press
the START key to resume copying.
INTERRUPTING A COPY RUN
INTERRUPT is used to interrupt a long copy run so that another job can be
done.
●
SORT or GROUP cannot be selected during interrupt copying. (Sort and
group can be performed only if an optional electronic sortring kit and an
optional SPF or RSPF are installed.)
●
INTERRUPT will not function during two-sided copying.
●
Two-sided copying cannot be performed during INTERRUPT copying.
Interrupting a copy run
p13-p27_206.p65
7/12/00, 12:05
26
