AR-5012 SIMULATION, TROUBLE CODES 10 - 8
26
64
Heater control setup during the scanner mode
When this simulation is executed, the currently set code number of heater control setup is displayed. Enter a desired code number of
heater control setup and press the PRINT switch, and the new setup is enabled.
30
01
Paper sensor status display
Indicates the paper sensor status using the lamps on the operation panel.
43
01
Fusing temperature setup (Normal copy)
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
04
Fusing temperature setup 2
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
05
Fusing temperature setup in duplex copy
In duplex copy, this setup value is added to the fusing temperature of single copy. When this simulation is executed, the current setup
of the code number is displayed. Enter the code number and press the PRINT switch to enable the setup.
09
Setup of fusing control of postcard size paper
Main
code
Sub
code
Content
Code number
Heater control setup
0
Heater control ON
* Default (Except for Europe)
1
Heater control OFF
* Default (For Europe only)
Sensor name
Display lamp
Before-resist paper sensor (PPD1)
Developer cartridge replacement lamp
Fusing section paper sensor (PPD2)
JAM lamp
Paper exit sensor (POD)
Photoconductor cartridge replacement lamp
2nd CS paper sensor (PPD3)
2nd cassette lamp
New drum cartridge sensor (PUIS)
Zoom lamp
Single manual feed paper sensor (MFD)
AE lamp
Code number
Set temperature (° C)
0
175
1
180
2
185
3
190
4
195 (* Default)
5
200
Code number
Set temperature (° C)
0
155
1
160
2
165
3
170 (* Default)
4
175
5
180
Code number
Temperature shift (° C)
0
±0° C * Default
1
– 8° C
2
– 6° C
3
– 4° C
4
– 2° C
5
±0° C
6
+2° C
7
+4° C
8
+6° C
9
+8° C
The default for Japan model is “1.”
Code number
Setup
0
Cancel * Default
1
Setup