5
INSTALLING THE PRINTER DRIVER
INSTALLATION IN WINDOWS 98/Me/2000 (USB CABLE)
1
The USB cable must not be connected
to the machine. Make sure that the cable
is not connected before proceeding.
If the cable is connected, a Plug and Play window
will appear. If this happens, click the "Cancel" button
to close the window and disconnect the cable.
2
Insert the CD-ROM into your CD-ROM
drive.
3
Double-click "My Computer" (
), and
then double-click the CD-ROM icon (
).
4
Double-click the "setup" icon (
).
5
Read the message in the "Welcome"
window and then click the "Next" button.
6
When you are asked how the printer is
connected, select "Connected to this
computer" and click the "Next" button.
7
When the interface selection screen
appears, select "USB" and click the
"Next" button.
8
Follow the on-screen instructions.
9
When the finish screen appears, click
the "OK" button.
10
Make sure that the power of the machine
is turned on, and then connect the USB
cable. (p. 8)
Windows will detect the machine and the Plug
and Play screen will appear.
11
Follow the instructions in the Plug
and Play screen that appears in your
version of Windows to begin the
installation.
This completes the installation of the software.
Configure the printer driver settings as explained in
"CONFIGURING THE PRINTER DRIVER" (p. 9).
The cable will be connected in step 10.
If the language selection screen appears after
you double click the "setup" icon, select the
language you wish to use and click the "Next"
button. (Normally the correct language is
selected automatically.)
Note
Note
In Windows 2000, if the following screen
appears while the files are being copied (the
message may appear more than once), click
the "Yes" button.
After the installation, a message prompting
you to restart your computer may appear. In
this case, click the "Yes" button to restart your
computer.
Caution
Note
!install̲ar5316̲5320.book 5 ページ ２００３年１２月２日 火曜日 午前９時４２分
