For copier models with one paper tray
Turn off the main switch of the copier and then remove the power plug
of the copier from the outlet.
1. Remove the right rear cover from the copier.
Remove the four screws and then remove the right rear cover from
the copier.
2. Remove the rear cover from the optional paper feed
unit.
Remove the two screws and then remove the rear cover from the
optional paper feed unit.
3. Attach the copier
Place the copier on the optional paper feed unit and remove the first
and second paper trays.
Connect the copier to the paper feed unit using four fixing plates and
two screws (M4 x 12) for each plate.
4. Connect the harness.
<1> Connect the cassette relay harness contained in the paper feed
unit to the MCU PWB of the copier.
<2> Remove the relay harness for dehumidifying heater connected to
the paper tray in the main unit.
<3> Connect the relay harness for dehumidification heater contained
in the optional paper tray to the optional paper tray.
<4> Store the harness in the harness holder.
·
For one tray type
·
For two tray type
5. Attach the right rear cabinet of the copier and the rear
cover(s) of the optional paper feed unit.
Attach the right rear cabinet of the copier using four screws, and
attach the rear cover(s) of the optional paper feed unit using two
screws respectively.
Screws
Screws
Right rear cover
Screw
Screw
Rear cover
Detailed view
Fixing plates
Fixing plates
Screws (M4 x 12)
Screws (M4 x 12)
Left of rear side
Right of rear side
Fixing plates
Fixing plates
Screws (M4 x 12)
Screws (M4 x 12)
Cassette relay harness
Harness holder
Relay harness for
dehumidification heater
Cassette relay harness
Harness holder
Relay harness for
dehumidification heater
