SPECIAL MODES
5-10
5
Press the [START] key.
NOTES
●
To perform tandem copying, the server machine
and client machine must meet certain conditions.
After the [START] key is pressed on the server
machine, the server machine verifies that the
conditions have been met. If the conditions have
not been met, tandem copying does not begin
and "TANDEM OUTPUT IS NOT ALLOWED.
OUTPUT ALL SETS USING MASTER
MACHINE?" appears in the display. To have the
server machine make all the copies, touch the
[OK] key. To cancel the job, touch the [CANCEL]
key.
• As an example, the following conditions must
be met when a staple finisher is installed on the
server machine and not on the client machine:
(1) If tandem copying is executed for a two-
sided copy job with the number of copies
set to 999 and "Non-staple" is selected,
tandem copying will take place.
(2) If tandem copying is executed for a two-
sided copy job with the number of copies
set
to
999 and "Staple" is selected,
tandem copying will not take place
because the client machine does not have
a finisher.
●
After the [START] key is pressed, if the client
machine cannot print because it is out of paper or
other reason, the server machine will print its half
of the job. The other half of the job will be stored in
the client machine and the job will be printed when
the client machine is able to print.
●
If auditing mode is enabled on both the server and
client machines, the same account number must
be entered on both machines.
●
If auditing mode is enabled on the client machine
but not on the server machine, tandem copying
cannot be performed.
To cancel the tandem copy function, touch the
[TANDEM COPY] key on the special modes screen
(step 2). The highlighted display will be canceled.
Summary of Contents for AR M550N - B/W Laser - Copier
