AR-M550/M620/M700 INSTALLATION MANUAL (AR-LC6) 2 - 5
a. Side plate size change-over
1) Remove the four fixing screws (blue) which are fixing the upper
and the lower sections of the side plate F and the side plate R.
2) Then fit the paper feed tray on the lower side of the side plate F
and the side plate R with the engraved marks of the side plates
according to the size, and insert it. Also fit the upper side to the
size and fix it with the four fixing screws (blue).
b. Auxiliary guide size change-over
1) When changing the size of the side plate R, check to confirm the
mark positions of "
" on the side plate R and the size guide
adjustment plate.
2) Loosen the auxiliary guide fixing screw (Flat screw 1pc).
3) Change the mark position (
▲
) of the auxiliary guide and the cas-
sette R from A4 to LT, and fix them with the fixing screw (flat
screw, 1pc).
At that time, adjust so that the mark positions (
▲
) on the auxiliary
guide and the cassette R are at the same positions of the mark
positions (
) of the side plate R and the size guide adjustment
plate checked in the procedure 1). (If the scale of the size guide
adjustment plate is at the center, set the position at the center. If is
it at 1mm toward the front side, set the position at 1mm toward the
front side.)
c. Rear edge shaft change-over
1) Remove the rear edge shaft fixing screw (blue) on the right side of
the paper feed tray, and remove the rear edge shaft.
2) Tighten the removed rear edge shaft with the fixing screw (blue
screw) and store it in the storage space inside the front cabinet.
F side
R side
F side
R side
A4
LT
[When LT size]
