A37159,SEC R90GC O/M
4
TINSEA986WRRZ-D31 SEC R90GC
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a
grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in
accordance with the National Electrical Code and local codes and ordinances. In the event of an electri-
cal short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric
current.
WARNING
–
Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 240 volt 60 Hz, AC only, 15 amp. protected electrical supply. It is
recommended that a separate circuit serving only this appliance be provided. The 240 volt circuit is
absolutely necessary for optimum cooking performance.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is
properly installed and grounded.
G R O U N D I N G I N S T R U C T I O N S
Receptacle Box Cover
3 Pronged Plug
(6-15P)
3 Pronged Receptacle
(6-15R)
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade ground-
ing plug and a 3-slot receptacle that will accept the plug on the high speed oven. The marked rating of
the extension cord should be AC 240 volt, 15 amp. or more.
Be careful not to drape the cord over the countertop or table where it can be pulled on by children or
tripped over accidentally.
Notes:
1. If you have any questions about the grounding or electrical instructions, consult a qualified
electrician or service person.
2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal
injury resulting from failure to observe the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the high speed oven to your radio or TV, check that the high
speed oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as
feasible or check position and signal of receiving antenna.
SEC R90GC O/M,P01-10
03.5.12, 6:05 PM
4