Sharp CD-BA120, Operation Manual

<P=004>

(Continued)

■

Disc number selection

1

When stopped, press the DISC SKIP button.

2

Press the 

0/R

  (

0R

) button.

●

The next disc playback will begin, after which each following
disc will be played sequentially.

Notes:

●

When the DISC SKIP button is pressed during playback,
playback will begin automatically from the next disc. (It is not
necessary to press the 

0/R

  (

0R

) button.)

●

When one of the disc number buttons (   1-   3) is pressed
during playback, playback of the selected disc will begin auto-
matically. (It is not necessary to press the 

0/R

  (

0R

) button.)

■

APSS (Auto Program Search System)

APSS automatically locates the beginning of any track.

To listen again to the track being played:
Press the 

5

 button for less than 0.5 seconds during playback.

To move to the beginning of the next track:
Press the 

4

 button for less than 0.5 seconds during playback.

●

To skip a number of tracks at one time, press the 

5

 or 

4

button repeatedly until the desired track number is shown.

●

To start playing at a desired track, press the 

5

 or 

4

 button

while in the stop mode to select the track number, and then
press the 

0/R

  (

0R

) button.

Note:

●

APSS can only search for music on a single disc.

■

Cue and review

1

Load a disc and begin playback.

2

Hold down the 

2

 button for audible fast forward, and hold

down the 

3

 button for audible fast reverse.

3

Normal playback will resume when the 

3

 or 

2

 button is

released.

Notes:

●

When the end of the disc is reached while cueing, "END" will
appear in the display and CD operation will be paused. (Even
though the next disc has been loaded, the disc will not be
switched.)
Press the 

3

 button for fast reverse or press the 

■

 (CD 

■

)

button to stop CD operation.

●

If the beginning of the disc is reached while reviewing, the
mode will automatically switch to normal playback at that point.

■

Random play

(Remote control operation)

The tracks on the disc(s) can be played in random order
automatically.

1

Load a disc(s) and close the disc tray.

2

Press the RANDOM button to begin random play.

●

"R" will appear.

Notes:

●

When using random play, be sure to press the 

■

 (CD

■

) button after you are through listening. 

Otherwise, the disc(s) will play continuously.

●

In random play the unit will select and play tracks
automatically. (You cannot select the order of the
tracks.)

To cancel random play:

Press the 

0/R

  (

0R

) button.

●

"R" will go out.

CD

DISC SKIP

RANDOM

DISC SKIP

CD-BA120(SEC) TINSE0299AWZZ

9