– 21 –
CD-BK3200V
Figure 21
Adjusting procedure
1. Turn the mode big gear approx. 37 degrees in the arrow direction.
2. Viewing from the front side of the mechanism, verify that the guide ribs
(CHANGE BOX L/R and STB HOLDER)of tray are as tall as each other.
3. If they are not, bend the lever for adjustment. (Refer to the details.)
Note: Also apply the same adjustment on the R side.
STB HOLDER HEIGHT ADJUSTING METHOD
47
46
10
11
45
42
LIFT GEAR A
43
41
32
35
40
44
33
30
Mark position
80
TOP PLATE F
37
°
(121)
OS LEVER
Bend this portion to adjust the STB HOLDER
When high
(Narrow the gap.)
When low
(Broaden the gap.)
Adjustment procedure
1. Rotate the MODE BIG GEAR by 37
°
in the arrowed direction.
2. Check that the guide ribs (CHANGE BOX L/R and STB HOLDER) on the arrowed
TRAY are at the same height when looked from the front.
3. If they are not, bend the OS LEVER to adjust them. (Refer to the detail drawing.)
Note: Adjust the R portion in the same procedure.
02(102) CHANGE BOX L RIB
03(147) STB HOLDER RIB
03(147) STB HOLDER RIB
04(103) CHANGE BOX R RIB