CD MECHANISM SECTION
Perform steps
and 10 of the disassembly method to
remove the CD mechanism.
Replacement of pickup (See Figs. 15-1 and
15-2.)
When replacingthe pickup, refer to “Cares when Handling
Assembly”.
(a) After removing the CD
according to the
disassembling procedure, remove the screws, shafts and
connectors in order of
and
and replace the
pickup.
(b) Fit a new
in reverse order of disassembling. After
lock it with the screw
Connect the connector and lead wire as it was.
The laser power adjustment is not necessary owing to
improvement of performance of pickup.
Note:
When replacing the pickup do not apply force to the turntable of
spin motor. Otherwise, the height of main
and turntable
may be varied.
After replacing the pickup
This new mechanism has been newly designed to enhance
remarkably its performance as compared to the former ones, so
that there is no need to adjust pickup posture.
After mounting the pickup. apply voltage to the slide motor, and
ascertain that it runs at DC
or less.
CD CHANGER MECHANISM SECTION
Removing the CD changer motor (See Figs.
15-3 and
1. Before
the motor mounting chassis, turn the load
gear and lift gear in the direction of the arrow as far as it will
2. Remove the 3 chassis screws (Al) which hold the loading
motor and lift motor.
3. Removethe other 2 screws (A2) which hold the loading motor,
and remove it.
4. Remove the last 2 screws (A3) which hold the lift motor, and
remove it.
How to remove a CD magazine when it cannot
be ejected (See Fig. 15-3.)
1. If the CD magazine is locked and cannot be ejected due to
trouble, Remove the cabinet, and turn the load gear
counterclockwise manually to eject the CD magazine. (See
Fig 15-3.)
R o c k
Figure 15-2
This changer
consists of 6 changers. Magazines are
by hand, and microcomputer
is not
performed.
tray unloading, disc
disc tray storage,
discharge and disc tray selection are performed by the
microcomputer.
1. For microcomputer operation, see the
table.
2. For the timing charts, see Figs.
and 17-2 shown
below.
Summary of Contents for CD-C500Z
