1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
ENGLISH
CD-DD4500
Preparation for Use
–
Speakers
–
Connecting the AC power lead
After checking all the connections have been made correctly, plug the AC
power lead of this unit into the AC socket. If you plug in the unit first, the unit
will enter the demonstration mode (see page 12).
Note:
Unplug the unit if it will not be used for a prolonged period of time.
Caution:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
To install the surround speakers on the wall
Sharp designed the surround speakers so you may hang them on the wall.
Be sure to use the correct type and size of screw, as shown below.
1. Drive one screw into the wall for each speaker, as shown in the illus-
tration.
Make sure that both the screw and the wall can support a load of 20 kg (45 lbs.).
Drive the screws, so the screw head extends about 5 mm (3/16") out from the
wall.
2. Install the surround speakers on the wall by inserting the screw heads
into the slots on the back of the speakers.
Power amplifier
Mid-to-high range
(200 Hz - 20 kHz)
Ultra-low range
(60 Hz - 200 Hz)
Pre-amplifier
Pre-amplifier
Power amplifier
L-ch
Tweeter
Woofer
Subwoofer
Speakers (continued)
Bi-amp system:
Each speaker unit has a built-in subwoofer (low frequency range) which is driven sepa-
rately from the woofer and tweeter (mid-to-high frequency range). Two independent
amplifiers which have individual frequency characteristics are used.
By amplifying separately the two frequency bands, clearer sound is achieved.
3.2 mm (1/8")
5 mm (3/16")
Min. 22 mm (7/8")
9 mm (3/8")
5 mm (3/16")
Wall mounting screw
Min. 17 mm (11/16")
Wall surface
Wall surface
E-10
http://www.usersmanualguide.com/
