04/1/28
CD-DH790NH_09 EN
E-8
9
1
7
6
5
4
3
2
1
Listening to the iPod (continued)
Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.
Note:
When navigating the iPod menus with remote control, do
not operate any of the buttons on the iPod unit. The volume
level is adjusted by pressing the VOL (+ or –) button on the
main unit or the remote control. Adjusting the volume on
the iPod unit gives no effect.
iPod operation:
The operations described below depend on the generation
iPod you are using.
System on operation:
When the main unit is powered on, the iPod unit will
automatically power on when docked in the unit (including
TIMER function/exclude USB function).
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked
iPod unit will automatically turn to stand-by mode.
■
To insert iPod adaptor
1
Press the ON/STAND-BY button to turn the power on.
2
Insert the iPod adaptor into the iPod dock and connect
your iPod.
■
To remove iPod adaptor
Insert the tip of a screwdriver (“–” type, small) into the
iPod adaptor hole as shown and lift upward to remove.
iPod
Dock connector
iPod (bottom)
iPod dock
iPod connector
iPod adaptor
■
iPod playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod button on the remote control or
FUNCTION button repeatedly on the main unit to
select iPod function.
3
Insert iPod unit in iPod dock of main unit.
4
Press the / button to start playback.
■
To disconnect iPod
■
Navigating the iPod menus
1
Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.
2
Use the TUNING (
or
) button on the remote
control to select an item on the menu and then press
ENTER button.
CD
USB
FUNCTION
FUNCTION
VOL
VOL
ON/STAND-BY
ON/STAND-BY
M I N I C O M P O N E N T S Y S T E M
CD-DH790
ON/STAND-BY
ON/STAND-BY
Summary of Contents for CD-DH790NH
Page 34: ...TINSZA531AWZZ 09J R MW 1 ...
