03/1/21
08-CD-E100H(H)E2.fm
E-20
ENGLISH
8
CD-E100H
T
a
pe Recor
d
ing
T
Recording from the radio
To stop recording:
Press the
button of TAPE 1.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
T
Dubbing from tape to tape
You can record from TAPE 2 to TAPE 1.
To stop dubbing:
Press the
button of TAPE 1.
T
Erasing recorded tapes
Note:
Make sure that the TAPE 2 is not in use.
1
Tune in to the desired station. (See page 16.)
2
Load a cassette into the TAPE 1 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button of TAPE 1.
4
Press the button of TAPE 1,
which also engages the but-
ton.
5
Press the button of TAPE 1 again to begin recording.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into
the TAPE 2 cassette compartment.
Insert a blank tape into the TAPE 1
cassette compartment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE button.
4
Press the button of TAPE 1.
5
Press the button of TAPE 1, which also engages the
button.
6
Press the button of TAPE 2.
The
button
of
TAPE
1
will
be
released automatically and dub-
bing from TAPE 2 to TAPE 1 will begin.
1
Load the tape to be erased into the TAPE 1 cassette compart-
ment with the side to be erased facing toward you.
2
Press the TAPE button.
3
Press the button of TAPE 1, which also engages the button
to begin erasing.
TAPE 1
TAPE 2