27
CD-ES222E
03/10/29
CD-ES222E(UK).fm
TINSEA002SJZZ
Referenc
es
Remote control
If trouble occurs
When this product is subjected to strong external interference (me-
chanical shock, excessive static electricity, abnormal supply voltage
due to lightning, etc.) or if it is operated incorrectly, it may malfunc-
tion.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power on again.
2
If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by
resetting it.
Clearing all the memory (reset)
1
Press the ON/STAND-BY button to enter the power stand-by
mode.
2
Whilst pressing down the CLOCK button and the DISC SKIP but-
ton, press the ON/STAND-BY button until "CLEAR" appears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet (CD
pickup, tape heads, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc (or cassette) in the unit until normal
playback is possible (about 1 hour). Wipe off any condensation on
the transmitter with a soft cloth before operating the unit.
Before transporting the unit
Symptom
Possible cause
z
The remote control does
not operate.
z
Is the AC power lead of the unit
plugged in?
z
Are the batteries inserted cor-
rectly?
z
Are the batteries dead?
z
Does the range or angle of use
exceed that shown on page 10?
z
Does the remote control sensor
receive strong light?
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
Remove all CDs inserted in the unit.
4
Press the OPEN/CLOSE button to close the disc tray.
Make sure that "NO DISC" is displayed.
5
Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power lead from the wall socket.
9
Downloaded from:
