E-24
CD-XP350W(A)E3.fm
02/1/23
CD-XP350W
ENGLISH
Ta
pe
R
eco
rd
in
g
- Reco
rd
in
g
t
o
a ca
sse
tt
e t
a
p
e
-
Recording from the radio
To interrupt recording:
Press the REC PAUSE (TAPE-2
) button.
To resume recording, press the same recording button you pressed in step 5. Other
buttons do not allow resuming.
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1
Tune in to the desired station. (See page 17.)
2
Load a cassette into the TAPE 2 cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the
button to choose one
side or both sides.
...
To record on both sides.
...
To record on only one side.
4
Press the REC PAUSE (TAPE-2
)
button.
Recording will be paused.
5
Press the ( ) button to record on side A, or the ( T-2) button
for side B.
To record on both sides, begin on side A. (If recording is started from side B, the
tape will not switch over to side A.)
Erase-prevention tab of cassette tapes:
z
When recording on a cassette tape, make
sure that the erase-prevention tabs are not re-
moved. Cassettes have removable tabs that
prevent accidental recording or erasing.
z
To protect the recorded sound, remove the tab
after recording. Cover the tab hole with adhe-
sive tape to record on the tape without the tab.
Side A
Tab for side B
Tab for side A
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette compart-
ment. Insert a blank tape into the TAPE 2 cassette compartment.
It is recommended that the recording tape is the same length as the master tape.
3
Press the TAPE (1 2) button until
"TAPE 1" appears on the display.
The reverse mode will be set to " ".
4
Press the REC PAUSE (TAPE-2
)
button.
Recording will be paused.
5
Press the ( ) button.
1
Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2
Press the TAPE (1 2) button until "TAPE 2" appears on the display.
3
Set the
button to " " to erase only one side and to "
" to erase both sides.
4
Press the REC PAUSE (TAPE-2
) button.
5
Press the ( ) button to erase side A, or the ( T-2) button to erase side B.
To erase both sides, begin from side A. (If erasing is started from side B, the tape
will not switch over to side A.)
Tuning (See page 17.)
