E-8
CD-XP500A(A)1.fm
02/3/11
CD-XP500A
ENGLISH
Prepar
ation for
Us
e
- S
y
s
te
m
c
onne
c
ti
o
n
s
-
!
Speaker connection
Connect the black wire to the minus (-) terminal, and the red wire to the plus (+) ter-
minal.
Caution:
!
Placing the speaker system
The left and right speakers have individual shapes. For best performance, place the
speakers according to the diagram below.
Note:
The speaker grilles are not removable.
!
Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear panel before plug-
ging the unit into a wall socket. If necessary, adjust the selector to correspond to the
AC power voltage used in your area.
Turn the selector with a screwdriver until the appropriate voltage
number appears in the window (110 V, 127 V, 220 V or 230 V - 240 V
AC).
!
Connecting the AC power lead
After making all connections, plug the unit. If you plug the unit first,
the unit will enter the demonstration mode.
Notes:
"
The unit will start the tape initialisation when plugged in to the AC socket. During
this process, initialising sound will be heard and the unit cannot be turned on. Wait
until the process is finished.
"
Unplug the AC power lead from the wall socket if the unit will not be in use for a
prolonged period of time.
Right speaker
Left speaker
"
Use speakers with an impedance of 6 ohms or more, as
lower impedance speakers can damage the unit.
"
Do not mistake the right and the left channels. The right
speaker is the one on the right side when you face the unit.
"
Do not let the bare speaker wires touch each other.
"
Do not allow any objects to fall into or to be placed in the
bass reflex ducts.
"
Do not stand or sit on the speakers. You may be injured.
Incorrect
Left speaker
Right speaker
Black
Red
(230 - 240 V, 50/60 Hz)
Wall socket
230V
240V
Demonstration mode (See page 10.)
