Sharp CP-DAB10NH, Operation Manual

04/1/28

XL-DAB10N 20H_001 EN.fm

E-4

9

8

7

6

5

4

3

2

1

9

System connections

The iPod with photo and video can be viewed by
connecting to a TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket on the rear of the unit.

Note:

Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple’s home page for
further information.

After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket. If you plug in the unit first, the unit will enter the
stand-by mode.

Note:

Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.

Remote control

Caution:

●

Replace all old batteries with new ones at the same
time.

●

Do not mix old and new batteries.

●

Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.

●

Do not use rechargeable batteries (nickel-cadmium
battery, etc.).

●

Installing the batteries incorrectly may cause the unit to
malfunction.

●

Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or
the like.

Make sure to unplug the AC power lead before making any connections.

Right speaker

(not supplied)

To video 
input socket

Wall socket

(AC 220 - 240 V ~ 50/60 Hz)

Video cable 

Black

Red

Left
speaker

TV

DAB/FM Aerial

■

Speaker connection

●

Connect the black wire to the minus 
(–) terminal, and the red wire to the 
plus (+) terminal.

●

Use speakers with an impedance of 
6 ohms or more, as lower 
impedance speakers can damage 
the unit.

●

Do not mistake the right and the left 
channels. The right speaker is the 
one on the right side when you face 
the unit.

Incorrect 

●

Do not let the bare speaker wires touch each other.

●

Do not allow any objects to fall into or to be placed in the
bass reflex ducts.

●

Do not stand or sit on the speakers. You may be injured.

■

Connecting iPod to a TV

■

AC power connection

■

Battery installation

1

Open the battery cover.

2

Insert the batteries according to the direction indicated
in the battery compartment.

When inserting or removing the batteries, push them
towards the (–) battery terminals.

3

Close the cover.