13
XL-UH220H
Basic Operation
Setting the clock (Remote Control only)
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the
or
button to display the time.
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not
appear in step 3, step 4 (for selecting the 24-hour or 12-hour
display) will be skipped.
To change the 24-hour or 12-hour display:
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
or
button to select
"CLOCK", and press the MEMORY button.
4
Press the
or
button to select 24-hour or 12-hour
display and then press the MEMORY button.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00"
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
5
Press the
or
button to adjust the hour and then
press the MEMORY button.
Press the
or
button once to advance the time by 1 hour.
Hold it down to advance continuously.
6
Press the
or
button to adjust the minutes and then
press the MEMORY button.
Press the
or
button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
1
Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 38 for details.]
2
Perform "Setting the clock" from step 1.
Summary of Contents for CP-UH220H
Page 41: ...MEMO MEMO 11 16 05 4 41 PM 1 ...
Page 42: ...MEMO MEMO 11 16 05 4 41 PM 3 ...
