SW
NO.
Data
NO.
Item
Switch selection and contents of functions
Initial value
User
program
No.
Remark
SW19
3
Output only in
case of
protocol
monitor error
Effective only when SW19-1 is set to 1 (YES). Used to
set whether protocol monitor is outputted only when a
communication is not completed normally due to a
communication error or it is outputted after completion of
every communication.
NO
0
4
Reserved
0
5
Reserved
0
6
Reserved
0
7
Time
designation 1
of
communication
record table
Used to set whether the communication record table is
printed at the designated time 1 or not.
Disable
0
139
8
Time
designation 2
of
communication
record table
Used to set whether the communication record table is
printed at the designated time 2 or not.
Disable
0
139
SW20
1
Line sound
monitor range
Used to set the line sound monitor range when the line
monitor function is used.
When set to “Until NSF signal send/receive”, monitoring
is made until the NSF signal is sent or received. When
set to “All”, monitoring is made for all until the line is
disconnected.
OFF
0
When set to
“11”, set to “00”.
2
0
3
Line monitor
display
Used to set whether the communication speed and the
reception level are displayed on the LCD or not.
NO
0
4
Operation
panel key
sound
Used to set whether the key click sound of FAX related
keys are made or not when operating in the FAX mode.
Ring
0
5
Receivable
memory
capacity left
Used to set the remaining memory capacity for
acceptance of call. (This is not the memory judgement
level during reception.)
128 Kbyte
0
6
Memory over
during reception
Used to set whether the received data are outputted or
destroyed when memory is over during reception.
Output
1
7
Reserved
0
8
Reserved
0
1: Only in case of an
error
0: After completion of
every communication (All
output)
1: Enable
0: Disable
1: Enable
0: Disable
SW20 Bit No.
1 2
OFF
0 0
Until NSF signal send/receive
0 1
All
1 0
1: YES
0: NO
1: Not ring
0: Ring
1: 64Kbyte
0: 128Kbyte
1: Output
0: Not output
DM-FX1
6 – 9
