2. Communication error codes
A. Error code identification
Communication error xx (xxxx)
(In print out, the communication error display is made. In FAX status
check, “NGxxxxxx” is displayed.
When transmission or reception is not executed normally due to distur-
bance in protocol signals and image signals by the trouble in the line,
the code of 6 digits is displayed on the transmission result check menu
(reception result check menu).
Upper 2 digits of a communication error code: 00 – 58 (error code) is
displayed. (Communication result code)
Lower 4 digits of a communication error code: Error code1, Error code
2
1) Refer to the communication result code.
2) Refer to error code 1.
3) Refer to error code 2.
(Error code 1 other than V.34 mode is “00”.)
<Communication result code>
Error code
(Communication
result)
Communication
report result
column
Communication
interruption content
0 – 31
For details of 0 –
31, refer to the
communication
result code.
Depends on the
communication
disconnection position.
For 16 or later, V.34
mode communication.
33
Busy
The calling side cannot
connect the line with the
other party.
34
Cancel
An interruption command
is made during
transmission or reception.
A reservation is canceled.
An interruption command
is entered with the
interruption key.
35
Power OFF
Power OFF during
transmission or reception
36
(Recording paper
empty)
37
(Recording paper
jam)
38
Reception
memory over
Memory over during
reception
39
(Discrepancy in
the number of
sheets)
40
(Interface not
accepted)
41
Transmission
length over
The length of
transmission data of one
page exceeds the range
during transmission.
42
Reception length
over
The length of reception
data of one page
exceeds the range
during reception.
43
Communication
(OK)
Communication enable
before transmission
44
Document error
A document jam during
direct transmission
Error code
(Communication
result)
Communication
report result
column
Communication
interruption content
45
(Image quality
error)
46
No response
from the other
party
The FAX signal from the
other party cannot detect
within T1 time.
47
(Communication
error)
48
OK
Communication normal
end
49
No send request
function on the
other party
The other party has no
send request function
when receiving a send
request.
The other party has no
data to send.
50
Send request not
accepted
DCN is received for DTC
when sending a send
request.
There is no data to send
when sending a send
request.
51
Send request
enable number
discrepancy
Discrepancy in the
enable number when
sending a send request.
Discrepancy in the
system number when
sending a send request.
52
No confidential
function on the
other party
The other party has no
confidential function
when sending a
confidential message.
(Including the other
company’s machines)
53
Confidential
function not
accepted
DCN is received for NSS
when receiving a
confidential message.
54
Confidential box
No. NG
A confidential box
number which is not
registered is directed
when receiving a
confidential message.
55
No interface
function on the
other party
The other party has no
interface function when
sending an interface
command.
56
Interface not
accepted
DCN is received for NSS
when sending an
interface command.
A receiving station
number which is not
registered is directed
when receiving an
interface command.
57
Interface ID
discrepancy
Discrepancy in the
interface ID when
receiving an interface
command.
58
Reception
inhibition number
Transmission is made
from a reception
inhibition number.
DM-FX1
10 – 2
