105
Function Setting
REC FUNCTION
VR MODE
VIDEO MODE
YES
NO
ALTERNATIVE REC SET
(ALTERNATIVE REC SETTING)
• This function is for diverting the recording destination from DVD-RW/R to HDD when a
recording set to DVD-RW/R cannot work due to the disc situation. This function works
in the following cases.
*
1
When there is not enough disc capacity left in DVD.
2
When an unrecordable disc is loaded.
3
When you forget to load a disc.
4
When a disc is playing within 2 minutes prior to the start of timer recording.
* In case
1
, when the remaining capacity of HDD is less than that of DVD, the
recording will continue on to DVD.
DVD AUTO INITIALISE
(DVD AUTO INITIALISING SETTING)
• This sets the Recorder so it automatically initialises any unused DVD-RW discs which
are loaded into the Recorder.
You can initialise in either VR mode or Video mode.
EXACT REC. SETTING
(EXACT RECORDING SETTING)
• This function works with timer recording (GUIDE Plus+/Timer Programme) onto DVD-
RW/R. If disc capacity runs low, and the programme cannot be recorded to the end,
this function will automatically change the recording mode so the programme will fit
into the disc.
(The recording mode will only be degraded so that the recordable time will extend.)
• If there is very little disc capacity left on the disc, the programme may not fit even if
Exact Recording is set.
• When recording in EP or MN1 mode, there is no lower recording mode, so Exact
Recording will not work.
YES
NO
HR480H-104-106
05.3.23, 5:09 PM
105
Summary of Contents for DV-HR400H
Page 131: ......
