GB
22
Setting the Remote
Control Code
• Two types of remote control codes operate
this Recorder: RC-1 and RC-2. If you
operate this Recorder by remote control
along with another SHARP DVD recorder or
DVD player placed next to it simulta-
neously, switching the remote control code
(both the Recorder and remote control) to
one of the signals (RC-1 or RC-2) will let
you operate only with this Recorder.
• Make sure to set the Recorder and remote
control to the same remote code. You can
not operate the Recorder if they are not set
to the same code.
Setting the Remote Con-
trol Code of the Remote
Example:
Setting the code to “RC-2”.
1
Press and hold
OPERATE
and
2
together for more than 5 seconds.
2
Press
OPERATE
of this Recorder
to see if you can turn it on/off.
• If you cannot, go to step
3
.
• To change the setting back to “RC-1”,
press and hold
OPERATE
and
1
in
the step
1
above.
Setting the Remote Con-
trol Code of the Recorder
3
Press
OPERATE
to turn off the
Recorder.
4
Press and hold
CHANNEL
"
and
CHANNEL
'
on the Recorder
together for more than 5 seconds.
• Each time this operation is performed,
the code of the Recorder toggles
between “RC-1” and “RC-2”. The front
panel display changes as the code
changes.
• Press
OPERATE
on the remote
control to see if you can turn on/off
the Recorder.
If remote control does not
work
Press
OPERATE
on the remote control and
check the front panel display (RC-1 or RC-2).
Set the remote control code according to the
display and press
OPERATE
to see if you
can turn on/off the Recorder.
Major Components
Front Panel
Display
CHANNEL
" '
HR480S-015-022
05.3.23, 9:41 AM
22
