93
EN
Recording
Disc Playback
Editing
Before you start
Connections
Getting started
Changing the
Setup menu
Others
VCR functions
DVD
“Repairing” appears on the
display.
Repairing
• If a power failure occurs or the mains cable is unplugged during recording,
finalising, formatting or editing (even after “Wait for a moment.” message
disappeared), a repairing process will begin automatically when the unit is
turned on next time. It may take several minutes up to about four hours.
In a case you intend to cancel the
Repairing process.
• If you intend to cancel the Repairing process, press
[OPEN/CLOSE EJECT
A
]
on the front panel, then select “Yes” with
[Cursor
s
/
B
]
and press
[ENTER]
.
After that, the disc tray will automatically open.
In case the Repairing
process is cancelled, the disc MAY NOT work
.
Repairing
Do you want to cancel a repairing process ?
When selecting “Yes”, the disc may not be
usable.
Yes
No
Others
Troubleshooting (cont’d)
* If the above remedies do not solve the problem, please call an authorised service centre.
VCR
Picture noise appears.
• Adjust tracking control for better picture by pressing
[PROG. / ]
while
you are playing back a video tape.
• Head cleaning for VCR may be necessary.
Refer to “AUTO HEAD CLEANING” on page 4.
The unit does not play back the
tape.
• No video tape is inserted.
Recording does not start
immediately after pressing
[VCR REC/OTR
I
]
.
• Make sure the video tape has a record tab when you record to a video tape.
If needed, cover the hole with cellophane tape.
The remote control does not
function.
• Check if a video tape is in the unit. Press
[VCR]
. Then, try again.
• Check if the Child Lock is activated. (See page 10.)
The motor rotates even when
playback / recording is stopped.
• The motor may rotate for the duration of approximately 5 minutes for
efficient operation. This is not a malfunction.
Symptom Remedy
http://www.usersmanualguide.com/