19
DV-SL2000W
H
Test of the remote control
Check the remote control operation after making all the connections.
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can
enjoy your system.
DV-SL2000
PULL OPEN
0.2 m - 6 m
(8" - 20')
H
To turn the power on
DV-SL2000
PULL OPEN
ON/STAND-BY
Press the ON/STAND-BY button:
If the power does not turn on, check the AC power lead is plugged in properly.
Preparation for Use
Battery installation
Turning the power on
1 Open the battery cover.
2 Insert the supplied batteries according to the direction indicated in
the battery compartment.
When inserting or removing the batteries, push them towards the
·
battery
terminals.
3 Close the cover.
Precautions for battery usage:
I
Replace all old batteries with new ones at the same time.
I
Do not mix old and new batteries.
I
Remove the batteries if the unit is not to be used for long periods of time.
This will prevent potential damage due to battery leakage.
Caution:
I
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
I
Incorrect installation may cause the unit to malfunction.
Notes concerning usage:
I
Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 “AAA” size batteries (UM-4, R03, HP-16 or
similar).
I
Periodically clean the transmitter on the remote control and the sensor on
the unit with a soft cloth.
I
Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
I
Keep the remote control away from moisture, heat, shock, and vibrations.
Preparation for Use
DV-SL2000W 17-25
11/22/06, 2:31 PM
19
