Sharp DW-P22A, Operation Manual

EN-11

ENG

LI

SH

When storing for a long 

period (not in use)

1. 

Operate the INTERNAL DRY 

OPERATION.

①

 Start operation. 

②

 Select the Internal 

Dry Operation. 

③

 Stop Operation. 

*Start the Internal Dry Operation, and 

stop automatically after approximate 90 

minutes. 

2. 

Dispose tank water and care the Main 

Unit.  

3. 

Store in a dry place away from direct 

sunlight. 

Plastic bag

♪

more 3 sec.

♪

～

ERROR DISPLAY

TROUBLESHOOTING

Before contact for service, check the following points to 

make sure that the problem is not a Main Unit malfunction.

If error occurs repeatedly, contact the Sharp authorized 

Service Center.

The room becomes hot.

•  The Main Unit generates heat during LAUNDRY DRY 

operation and DEHUMIDIFY operation and the room 

temperature will rise. Warm air will be come out from 

the air outlet, but this is normal and does not indicate a 

problem with the Main Unit.

The Main Unit does not dehumidify.

• 

The dehumidification level varies with the size, structure, 

temperature and humidity level of the room. When room 

temperature or humidity level is low, the dehumidification 

level will be low in general.

•  Check whether the Back Panel is clean. 

•  Check whether the air outlet or air inlet is not  blocked.

Sounds 

•  The Main Unit may make clicking or ticking sounds 

when it is generating ions. 

• 

The Main Unit may seem rather loud for the first 2 to 

3 minutes when the Main Unit is turned on. This is the 

sound of the compressor starting-up and is perfectly 

normal.

•  A soft, swishing noise can be heard immediately after 

the Main Unit is turned on or off, and also during 

operation. This is the sound of the refrigerant flowing 

inside the Main Unit.

The sound is too loud.

• 

The Main Unit will sound loudly for the first few seconds 

upon power-on when the room temperature is low. 

•  Check whether the Main Unit is placed on a stable and 

level floor.

•  Check whether the Back Panel is not clogged. 

There is a discrepancy between the 

Main Unit’s Humidity Monitor and 

another hygrometer in the room. 

• 

There is a difference in the humidity level within the 

same room.

• 

The sensor have different measurement parameters. 

The water leaks. 

•  Check whether the main unit is placed horizontally. 

•  When draining continuous, check whether the hose is 

inserted all the way seated.

•  If the Water Tank is full, drain the water.

•  If the Water Tank is not properly placed, 

place the Water Tank correctly.

•  The Main Unit is operating with the 

DEFROST mode.

• 

Laundry DRY (Auto) operation has 

completed, and the operation has 

stopped.

•  The operation has stopped with the 

Auto Off function.

•  Unplug the Main Unit, wait one 

minute, and then plug the Main Unit 

in again.