11
GENERAL INFORMATION
3. Changing Entered Characters and Expres-
sions
To change a character or expression before executing the calculation, follow the
procedure below.
Move the cursor to the location for correction. The new content will be inserted to the
left of the cursor when entered (during Equation edit mode).
Move the cursor to the character or expression to be changed, and enter a new
character or expression. (When the one line edit mode is selected)
•
d
: deletes an entry. When this key is pressed, the character or expression where
the cursor is located is deleted.
•
Ú
: moves the cursor backward. Each time
Ú
is pressed, the cursor moves
one space to the left and deletes the character or expression entered in that
location.
•
Ï
◊
: after pressing these keys, a character or expression can be inserted to
the left side of the cursor. (When the one line edit mode is selected.)
*
When the INSERT mode is selected, the cursor changes to the “ ” symbol.
*
When the INSERT mode is selected, the mode stays active until
Ï
◊
are pressed
again. In the equation edit mode (see CHAPTER 1 “11.Edit Modes” on page 25), the
INSERT mode automatically becomes active.
•
¬
: clears an entire expression that has been entered and the result of the
previous calculation.
<Example>
To change “
÷
” in the expression “(100+256)
×
2
÷
85–9”
to, “
×
”.
After entering
(
100
+
256
)
j
2
/
85
-
9 , enter
<
<
<
<
<
d
j
®
to make the change.
EL-9650-(01)En (001-036)
8/1/00, 12:04 PM
11
Summary of Contents for EL-9650
