11 |
P a g e
Time:
•
Enter in the order of hour, minutes, then press
to
complete the entry.
(There is no entry available for the
seconds’ value. The
clock starts at zero second.)
•
If the hour/minute digit is less than 10, it is not
necessary to enter the first digit “0”.
•
Use
to separate hour and minute values.
•
When
is pressed, the number entered is
evaluated
and displayed as “time” if the value is within
the
following range; “Error” is displayed otherwise, and
the previously set time is restored.
Hour: 0 - 23 (24-hour system for the hour entry),
Minute: 0
– 59
Conversion rate:
•
Press
twice, enter the conversion rate, followed by
.
•
A maximum of 6 digits can be stored (decimal point is
not counted as a digit).
Tax / discount rate:
•
Press
twice, enter the tax rate, followed by
.
•
Press
twice, enter the discount rate, followed by
then
.
•
A maximum of 4 digits can be stored (decimal point is
not counted as a digit).
Note:
•
Be sure to set this selector to the “
” position after
storing an each rate.
•
For the conversion rate and the tax / discount rate, a
single value can be stored for each. If you enter a new
rate, the previous rate will be cleared.
Summary of Contents for EL1197PIII - Printing Calculator, 12-Digit
