Sharp ES-HK700G, Operation Manual

Please install and adjust the machine according to the requirements of the manual. 

Correct operation is very important for your safety.

Unpacking

Unpack the carton and take out the bottom cover.
Open the top lid of washing machine and take out all of the accessories.
Remove all wrappers,  including the polystyrene base.
You are advised to keep all the packaging for reuse in case the machine is to be 
transported again. 

Positioning

     Make it horizontal.

  Use a tied thread with plumb to check 

  if it is horizontal.

    Adjust the adjustable foot

     and twist the adjustable foot.

2) Fasten the nut after adjustment.

Installing the bottom cover

1

°

Adjustable nut

Adjustable

            foot

1) Lift up the adjustable foot gently, loose the adjustable nut

Fixing clamp

Scissors

Bottom cover

The base

The distance between the washing machine and the wall should be  more than 50mm,

and the maximum allowable angle of the shank base of the machine is 1°

.

The slanting or rough ground may cause operating stopped or unstable, please adjust it 

with the following methods:

Let the back of washing machine incline forward, 

make the side of the bottom cover with sticker 

description facing outside. Insert it to the bottom 

of washing machine along the direction of the 

arrow.
Remove two fixing clamp by scissors, insert it on 

on the cover's aloted holes as shown on the figure 

(gently pull fixing clamp and it should not be pulled 

out). Make the bottom cover fixed on the base.