1 – 6
UX-178C/188C/108C/118C
FO-175LU/375C
4. Clearing a jammed document
If the original document doesn’t feed properly during transmission or
copying, or DOCUMENT JAMMED appears in the display, first try press-
ing the START key. If the document doesn’t feed out, open the opera-
tion panel and remove it.
Important: Do not try to remove a document without opening the op-
eration panel. This may damage the feeder mechanism.
1
Pull the release marked PANEL RELEASE toward you and open the
operation panel.
2
Remove the document.
5. Clearing jammed fax paper
1
Pull the release marked PANEL RELEASE toward you and open the
operation panel.
2
Remove the paper roll.
•
UX-178/188/FO-375: If any pieces of paper are stuck in the cut-
ter, remove them with caution.
•
UX-178/188/FO-375: Press the START key to reset the cutter.
3
Cut off the wrinkled part of the paper.
4
Reload the paper.
•
Jammed fax paper is often caused by improper loading. Be sure
to carefully follow the instructions for paper loading given in "Load-
ing the Fax Paper" in page 1-5.
5
If the display still shows PAPER JAMMED (UX-178/188/FO-375 only)
If the display still shows PAPER JAMMED after you press the START
key in Step 2 above, the cutter is still engaged in the cutting position.
To open the cutter, turn the fax up on its rear end and insert any long,
rod-like object with a flat or blunt end into the hole marked CUTTER
RESET. Continue to push the rod in until you feel it move a lever
inside the machine.
CUTTER
RESET
SPEED DIAL
REDIAL
HOLD/SEARCH
SPEAKER
ABC
DEF
JKL
MNO
GHI
TUV
WXYZ
PQRS
Press this key to delete
the letter highlighted by
the cursor.
Press this key to change
case.
Press this key to move
the cursor to the left.
Press this key to move
the cursor to the right.
Press either key repeatedly to select
one of the following symbols.
