<P=006>
General problems
Problem
Check and remedy
Nothing appears in the
display.
••
Make sure the power cord is properly
plugged into a power outlet.
••
Connect another electrical appliance to the
outlet to see if it has power.
The machine does not
respond when you press
any of its keys.
••
If a beep sound is not made when you
press the keys, unplug the power cord and
then plug it back in several seconds later.
Automatic document
feeding does not work for
transmission or copying.
••
Check the size and weight of the document
(see
Documents You Can Fax, Copy, and
Scan
in Chapter 2).
Voice calls taken on an
extension phone are
interrupted by the Sharp
MFP.
••
The Sharp MFP may interrupt during a
voice call if the reception mode is set to
ANS. To prevent interruption on a touch-
tone extension phone, press any three keys
on the extension phone after answering.
(Note: Do not enter the code to activate fax
reception.)
No reception occurs
when polling is attempted.
••
Make sure you have not run out of paper.
••
Make sure the transmitting machine is in
FAX reception mode.
••
If the transmitting machine has polling
security, make sure that your fax number
has been entered both in your machine and
in the transmitting machine.
Bell Tinkle
(New Zealand)
••
The operation of this equipment on the
same line as the telephone or other
equipment with audible warning devices or
automatic ring detectors will give rise to bell
tinkle or noise and may cause false tripping
of the ring detector. Should such a problem
occur, contact your authorised Sharp
Service Centre for information.
Problems and Solutions
11-7
