UX-108U/178U/188U
FO-375U
3. 12. Entry data receive
In this mode, the registered data sent from the other machine are re-
ceived and the received data are registered in the own machine. When
this mode is used for receiving, the other machine must be in the entry
data send mode.
After receiving is completed, the following lists are printed.
1. Telephone list data
2. Sender register data (The passcode No. is also printed if the poling
function is provided.)
3. Optional setting list
4. Soft switch content
5. Junk fax number list
6. Timer reservation list (only model which timer communication is
possible)
2 – 4
3. 13. Cutter aging (Cutter model only)
The mode is used to continuously cut the recording paper to approx. 10
mm and display the number of cutting times.
(Unless the memory clear is executed, the number of cutting times is
integrated.)
In the following cases, the operation is stopped.
1. The stop key is continuously pressed.
2. There is no recording paper.
3. The recording paper is jammed.
4. How to make soft switch setting
To enter the soft switch mode, make the following key entries in sequence.
Press FUNCTION
9
8
7
START
START
Press FUNCTION key.
Press
key.
Press
key.
Bit1 - 8 are set.
Soft SW-A2 - SW-L2 are set.
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A2 = 0 0 0 0 0 0 0 0
S F T SW-L2 = 0 0 0 0 0 0 0 0
Press
key during setting.
To finish the settings halfway between
SW-A1 and SW-L2, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW Nos. remain in effect.
The soft switch mode is terminated.
S F T SW-A1 = 0 0 0 0 0 0 0 0
START
DATA No. 1 2 3 4 5 6 7 8
When the COPY key is pressed, the
contents of soft switches are printed.
Summary of Contents for FO-375
Page 61: ...6 7 UX 108U 178U 188U FO 375U Control PWB parts layout Top side ...
Page 62: ...6 8 UX 108U 178U 188U FO 375U Control PWB parts layout Bottom side ...
Page 64: ...6 10 UX 108U 178U 188U FO 375U TEL LIU PWB parts layout ...
Page 66: ...6 12 UX 108U 178U 188U FO 375U Power supply PWB parts layout ...
