1 – 1
UX-44U
FO-55C
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Automatic dialing:
Rapid Key Dialing: 5 numbers
Speed Dialing: 35 numbers
Thermal paper:
Initial starter roll (included with machine):
32 ft. (10 m)
Recommended replacement roll:
FO-20PRw, 98 ft. (30m), 0.5" core
Paper cutting method:
Tear off by hand
Modem speed:
9600 bps with automatic fallback to lower
speeds
Transmission time* :
Approx. 15 seconds
Resolution:
Horizontal: 203 pels/inch (8 dots/mm)
Vertical:
Standard: 98 lines/inch (3.85 lines/mm)
Fine/Halftone:
196 lines/inch (7.7 lines/mm)
Super fine:
391 lines/inch (15.4 lines/mm)
Automatic document feeder: 5 pages max. (20 lb paper)
Halftone (grayscale):
64 levels
Display:
16-digit LCD display
Compression scheme:
MR, MH, Sharp (H2)
Applicable telephone line:
Public switched telephone network
Compatibility:
ITU-T (CCITT) G3 mode
Input document size:
Automatic feeding:
Width: 5.8 to 8.5" (148 to 216 mm)
Length: 5.5 to 11" (140 to 279 mm)
Manual feeding:
Width: 5.8 to 8.5" (148 to 216 mm)
Length: 5.5 to 23.6" (140 to 600 mm)
Effective scanning width:
8.3" (210 mm) max.
Effective printing width:
8.3" (210 mm) max.
Contrast control:
Automatic/Dark selectable
Reception modes:
Fax/Tel
Copy function:
Yes
Telephone function:
Yes (cannot be used if power fails)
Power requirements:
120 V AC, 60 Hz
Operating temperature:
41 - 95
°
F (5 - 35
°
C)
Humidity:
Maximum: 85 % RH
Power consumption:
Standby: 3.6 W
Maximum: 100 W
Dimensions:
Width: 12.0" (304 mm)
Depth: 9.3" (236 mm)
Height: 4.8" (122 mm)
Weight:
Approx. 5.7 lbs. (2.6 kg)
*
Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp
special mode, excluding time for protocol signals (i.e., ITU-T phase C
time only).
Note: The facsimile machine is Year 2000 compliant.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for procduct
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.
Summary of Contents for FO-55
