<P=003>
If you don’t want the document to be transmitted from memory, you can press the
DOCUMENT key after loading the document. In this case, the document will not be
scanned until the fax completes all previously set operations and the connection to the
receiving party is made. (To transmit the document ahead of any documents waiting in
memory for transmission, press the PRIORITY key.)
The FO-5600 can hold approximately 50 pages of average content in memory. Less
pages can be held if any were scanned using fine or halftone resolution. A variety of
memory add-on options are available from your dealer if you need to expand memory.
♦
The amount of memory currently occupied appears as a percentage ("M:00%") in
the display.
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY FULL will
appear in the display. If Option Setting 22 (Quick on-line) is set to YES, the
transmission will be cancelled and you will need to retransmit all pages of the
document. (If a page remains in the scanner, open the operation panel by squeezing
the release marked "PULL OPEN" and remove it.) If Option Setting 22 is set to NO,
press the START or STOP key as follows:
♦
Press the START key if you want to transmit the pages which have been stored up
to that point in memory. The remaining pages will be ejected from the feeder. After
transmission, the memory will be cleared and you can transmit the remaining
pages. You will also need to transmit the page which was being scanned when the
memory filled up.
♦
Press the STOP key if you want to cancel the entire transmission.
If you do not press the START key or the STOP key within one minute, the
transmission will be cancelled and the pages already scanned cleared from memory.
You will need to retransmit all pages of the document.
Memory Retransmission
If a line error or power failure occurs during any type of memory transmission, your fax
will automatically redial the number and attempt to complete the transmission.
Retransmission will begin from the page which was being transmitted when the error
occurred.
Your fax has been set at the factory to make 2 attempts at retransmission, with each
attempt made 5 minutes after the previous attempt. If desired, you can change the
number of attempts by changing Option Setting 16, and change the interval between
each attempt by changing Option Setting 17. See Chapter 5, "Optional Settings".
♦
To stop retransmission, press the STOP key.
♦
The numbering of pages retransmitted will begin from "1" again.
♦
If the error or power failure occurs during transmission of a cover sheet, retransmis-
sion will not take place.
SENDING DOCUMENTS
BASIC OPERATIONS
3-3
Summary of Contents for FO-5600
Page 7: ...vi ...
Page 91: ...5 6 OPTION SETTINGS ...
Page 106: ...TROUBLESHOOTING 8 7 ...
Page 107: ...8 8 TROUBLESHOOTING ...