ENGLISH
E-15
MAIN UNIT
To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to
remain, they may become hard to clean.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
Do not use volatile fluids
Benzene, paint thinner, polishing powder, etc., may damage the surface.
Do not use detergents
Detergent ingredients may damage the unit.
Keep the unit away from water
ODOUR
SENSOR
Remove dust from the sur-
faces of the sensor open-
ings with a vacuum cleaner.
Odour
Sensor
PRE-FILTER
Remove the Filter Frame, Clean the top surface of the
Pre-Filter lightly with a vacuum cleaner.
If it is contaminated heavily, remove it from the Filter Frame
to wash it.
NOTE
• In case of washing, use a soft
brush etc. and cold/warm water.
• Metal brushes or scrub brushes
may cause damage.
• After washing, leave it in the
shade until it gets dried. Then
place it back to the Filter Frame.
SPECIFICATIONS
* The applicable floor surface area is the surface area for when operating the unit in MAX fan level.
Applicable floor surface area indicates the space where a certain amount of dust pollution can be
removed in 30 minutes.
Pre-Filter
About the reduction of standby power
In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this
product consumes about 1.0W of standby power.
For the conservation of energy, remove the power plug when not using the unit.
Fan Speed
Operation
~21 m
2
2.5m
MAX
29 W
168m
3
/hour
SILENT
3.1 W
30m
3
/hour
482mm(W)x142mm(D)x337mm(H)
482mm(W)x228mm(D)x373mm(H) (Stand installation)
6.2kg
Weight
Model
Power Supply
Fan Speed Adjustment
Rated Power
Air Flow Volume
Applicable Floor Surface
Cord Length
FU-28H-A
220V 50Hz
Dimensions
Summary of Contents for FU-28H-A
Page 2: ......
Page 35: ...中文 ...
Page 36: ...SHARP CORPORATION Printed in Japan TINS A140KKRZ 04KK ...
