Sharp FU-28H, Operation Manual

ENGLISH

E-15

MAIN UNIT

To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to
remain, they may become hard to clean.

Wipe with a dry, soft cloth

For stubborn stains or dirt, use a soft cloth dampened with warm water.

Do not use volatile fluids

Benzene, paint thinner, polishing powder, etc., may damage the surface.

Do not use detergents

Detergent ingredients may damage the unit.

Keep the unit away from water

ODOUR

SENSOR

Remove dust from the sur-
faces of the sensor open-

ings with a vacuum cleaner.

O d o u r
Sensor

PRE-FILTER

Remove  the  Filter Frame, Clean the top surface of the
Pre-Filter lightly with a vacuum cleaner.
If it is contaminated heavily, remove it from the Filter Frame
to wash it.

NOTE

• In case of washing, use a soft

brush etc. and cold/warm water.

• Metal brushes or scrub brushes

may cause damage.

• After washing, leave it in the

shade until it gets dried. Then
place it back to the Filter Frame.

SPECIFICATIONS

Model
Power supply
Fan speed Adjustment
Rated Power
Air Flow Volume
Applicable Floor Surface
Cord Length
Dimensions
Weight

Fan speed

Operation

MAX

29 W

168m

3

/hour

SILENT

3.1 W

30m

3

/hour

* The applicable floor surface area is the surface area for when operating the unit in MAX fan level.
(JEM 1467, The Japan Electrical Manufacturers’ Association)
Applicable floor surface area indicates the space where a certain amount of dust pollution can be
removed in 30 minutes.

About the reduction of standby power

In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this
product consumes about 1.0W of standby power.
For the conservation of energy, remove the power plug when not using the unit.

Pre-Filter

FU-28H-S

220-240V  50/60Hz

~21 m

2

2.5m

482mm(W)x142mm(D)x337mm(H)

6.2kg