26
(Continued)
About the TP and TA indicators
TP indicator
TA indicator
Meaning
Not lit
Not lit
This programme does not carry traffic announcements nor
does it refer, via EON, to a programme that does.
Not lit
Lit
This programme carries EON information about another pro-
gramme which gives traffic information.
Lit
Not lit
This programme carries traffic announcements but none are
currently on air and may also carry EON information about
other traffic announcements.
Lit
Lit
A traffic announcement is currently on air on this programme.
In the following cases, the EON stand-by mode will be cancelled.
When the unit is set in the stand-by mode.
When the unit is switched to another band in the EON stand-by mode.
When you change the FM station whilst in the EON stand-by mode.
When a preset call is made.
Notes:
During the same programme as the specified PTY (or TA) is being broadcast on the station you are receiving, the unit
will not switch to other network station.
If there are more than two other network stations you want to listen to, compare the strength of each station's signal and
tune in the station with the strongest signal. (EON-AF) However, if the frequency of other network station has been stored
in the preset channel memory, the unit will switch to that preset channel.
To cancel the ON (other network) station tuned in by the EON system and to return to the original station, press the EON
button.
After the unit returns to the original station, the stand-by mode will still be active. (The "TI" or "PTY" will remain lit.)
The unit will not switch from the ON station to another network station. The unit returns to the original station.
When the unit switches automatically to "other network" station, "WEAK SIG" will appear and the unit will return to the
original station if there is any problem with this station or the station cannot be received properly.
Even if the unit switches from the station you are listening to directly to some "other network" station, the unit will search
for the station with the strongest signal and switch to it if the signals from the other network stations are very weak. How-
ever, if the signals from all the other network stations are very weak, or if the tuning conditions are very bad (due to elec-
trical noise), the unit will stop searching, "WEAK SIG" will be displayed, and the unit will return to the original station you
were receiving.
